Grossunternehmen |
2000 Angestellte (Schweiz) |
| Temporär: Ja | Pensum: 100% |
| CH-5303 Würenlingen | Sprache: en |
| Homepage |
The Paul Scherrer Institute PSI is the largest research institute for natural and engineering sciences within
Switzerland. We perform cutting-edge research in the fields of future technologies, energy and climate, health
innovation and fundamentals of nature. By performing fundamental and applied research, we work on sustainable solutions
for major challenges facing society, science and economy. PSI is committed to the training of future generations.
Therefore, about one quarter of our staff are post-docs, post-graduates or apprentices. Altogether, PSI employs 2300
people.
For the PSI Center for Accelerator Science and Engineering we are looking for a
Trainee in Advanced Measurement Techniques for HTS magnets
Your tasks
At PSI, there is a growing interest in superconducting magnets build with Hight Temperature Superconductors (HTS)
technology. The need to characterize these magnets during dynamic operation is becoming increasingly important.
Although HTS magnets allow for large operational margins, they might exhibit poor field quality and/or excessive AC
losses, depending on the practical design.
To assess field quality (i.e., field harmonics), the most suitable measurement technique is the rotating coil method.
However, the measurement systems currently available at PSI are designed and implemented for magnets operating under
steady-state conditions. As a result, the entire computational burden is shifted to post-processing. Moreover, data
streaming during coil signal acquisition is time-limited (typically 5 s). This significantly simplifies the control
software, as there is no need for sophisticated design patterns to manage the continuous reading and storage of large
data volumes, which could otherwise create a bottleneck in the acquisition speed.
To meet the requirements of field quality measurements during dynamic magnet operation, a portion of the computational
workload must be moved to real-time signal processing. This includes the numerical integration of the coils voltage
signals once they have been converted into the digital domain. This approach preserves measurement accuracy while
reducing the required data transmission rate, owing to the downsampling inherent in the integration process.
Typical measurement setups for AC losses in HTS magnets involve the use of expensive lock-in amplifiers. With
appropriate hardware and clever signal processing, these instruments can be replaced by the same hardware used for
real-time rotating coil measurements.
Within the framework of implementing real-time processing of rotating coil signals and the potential reuse of hardware
for AC loss measurements, the objective of this work is to design, test, and commission the numerical integration of
measurement coil signals on an NI FPGA board. The main tasks associated with the internship are:
- Get familiar with NI FPGA reconfigurable modules
- Design and develop NI LabVIew FPGA code that meets measurement requirements
- Commission the FPGA application during field quality measurements of actual magnets
- Integrate the new HW and SW in the existing Rotating Coil measurement control application
Your profile
- You are a student in electrical/electronic engineering, and you are at least in your ultimate year of undergraduate
study (minimum 4 semesters)
- You have a clear understanding of FPGA technology
- You have an interest in numerical signal processing
- You have not yet completed your Master’s thesis
We offer
Our institution is based on an interdisciplinary, innovative and dynamic collaboration.
The contract will be limited to 7 months.
For further information, please contact Dr Giuseppe Montenero, phone +41 56 310 52 61.
Please submit your application online for the position as a Trainee (Index-Nr. 8431-28384).
Paul Scherrer Institute, Human Resources Management, Lara Essig, 5232 Villigen PSI, Switzerlandwww.psi.chApply now